financialvova.blogg.se - Cateye cc rd300w

#CATEYE CC RD300W INSTALL#
#CATEYE CC RD300W MANUAL#
#CATEYE CC RD300W TV#

#CATEYE CC RD300W MANUAL#

When attaching the bracket to the handlebarĥ Magnet 6 Sensor rubber pad 7 Bracket rubber pad 8 Nylon ties (x2)īefore using the computer, please thoroughly read this manual and keep it for future reference.

#CATEYE CC RD300W INSTALL#

* Install the sensor as close to the upper If the speed is not displayed, check that conditions * After installation, rotate the front wheel gently to check that the speed is displayed on theĬomputer. Stem if its back does not face the sensor as shown inĪttach the bracket to the stem or handlebarĬaution: Round off the cut edge of the bracket band to prevent injury. * The computer may not function appropriately on some (Option)Ĭaution: Make sure that the back of the computer faces the sensor.

Stem, bracket can be mounted using the Bracket Holder and nylon ties. The clearance between the sensor surface and the magnet must not exceed 5 mm. The magnet must pass through the sensor zone. The back of the computer must face the sensor. The distance between the computer and the sensor must not exceed the transmission range of 70 cm. With the riders weight on the bike, roll the wheel one tire revolution in a straight line and mark the ground when the valve stem is perpendicular to the ground again. With the valve stem perpendicular to the ground, mark the pavement at the valve stem. 24h ↔ 12h, or increase the value Switch the screen or move digits (by pressing & holding) Preparing the computer Battery case cover Push! When the computer is mounted on the bracket : Speed unit : Wheel size icon : Sensor signal reception icon Measure wheel circumference (L) of your bike To get the most accurate calibration do a wheel roll out. Set the clock When MODE is pressed and held, “Displayed time”, “Hour”, and “Minute” will appear, in this order. * Refer to the tire circumference reference table.

Enter the tire circumference Enter the tire circumference of your bicycle in mm.

Select the desired speed units Select “ ” or “ ”. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co.,Ltd.May void the user ’s authority to operate the equipment.Ĥ km/h ↔ mph Increase Move digits (by pressing & holding) Register the setting Register the setting Clear all data (initialization) Press the AC button on the back. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1)This device may not cause harmful interference,and (2)this device must accept any interference received,including interference that may cause undesired operation. Using with other wireless devices in close proximity.

#CATEYE CC RD300W TV#

Close to a railroad crossing, railway tracks, TV stations and/or radar base.

Near a TV, PC, radio, motor, or in a car or train.

Interference may occur, resulting in incorrect data, if the computer is:

Signals can be received only when the back of the computer is facing the sensor.

The transmission distance may be shorter due to low temperature or low battery.

Signals cannot be received if the distance between the sensor and the computer is too great.

When adjusting the wireless sensor, note the following: Wireless Sensor The sensor was designed to receive signals within a maximum range of 70 cm, to reduce chance of interference.

LCD screen may be distorted when viewed through polarized sunglass lenses.

Dispose of used batteries according to local regulations.

When cleaning the computer, bracket and sensor, do not use thinners, benzene, or alcohol.

Over-tightening can damage the bracket threads.

Tighten the dial on the Flex-Tight bracket by hand only.

Pressing hard on other areas can result in malfunction or damage to the computer.

When using the computer installed on the bracket, change the MODE by pressing on the three dots below the screen.